Installation Procedure: Electric Parking Brake (EPB) Actuator Kits
01.
Attach the O-ring seal
Apply the genuine rubber grease to the new O-ring seal and attach it to the cylinder assembly
![install-EPB-Step1](https://www.advicsaftermarket.com/wp-content/uploads/2023/10/install-EPB-Step1.jpg)
02.
Install the actuator
Attach an actuator to a cylinder assembly with bolts included with ADVICS actuator kit
![install-EPB-Step2](https://www.advicsaftermarket.com/wp-content/uploads/2023/10/install-EPB-Step2.jpg)
03.
Connect the actuator to the electric system
Plug in the parking brake wire to the cylinder assembly
![install-EPB-Step3](https://www.advicsaftermarket.com/wp-content/uploads/2023/10/install-EPB-Step3.jpg)
Caution!
Failure to follow recommended procedures may cause brake failure and injury. Always consult the manufacturer’s vehicle specific service manual for reference.